C2g 22391 One-Console KVM Switches Bedienungsanleitung

Table of Contents Introduction Overview……………………………………..………….…………1 Features………………………………………..….…………….…3Configurations………………….………………..………………...4

18 computers. The non-volatile memory stores the Scan Type setting.  Scan Rate Sets the duration of a computer displayed in Auto Scan mode. The o

20 Hot-key commands Hot-key command is a short keyboard sequence to select a computer, to activate computer scan, etc. The KVM Switch interpret

22 ------------------------------------------------------------ Cascade ConfigurationCascade ConfigurationCascade ConfigurationCascade Config

24 For OSD model: After connection completes, you should re-activate the OSD menu to check if the Master recognizes the Slaves. A triangle mark (

26 Operation On power up, the KNV2108D and KNV2116D are in Idle mode broadcasting VGA signal from the selected computer and detecting for keybo

28 Troubleshooting: Ensure that all cables are well seated. Check that keyboard/mouse cables are not swapped. Label and bundle the cables for eac

30 Limited Warranty IN NO EVENT SHALL THE DIRECT VENDOR'S LIABILITY FOR DIRECT OR INDIRECT, SPECIAL, INCIDENTIAL OR CONSEQUENTIA

2 Automatic Mouse Conversion The KVM Switch enables you to connect computers with PS/2 or serial mouse ports (using adapters supplied with each

4 Configurations The KVM Switch has several models each supporting a different number of computers. For applications with a large number of compu

6 7 ------------------------------------------------------------------------------------------------ InInInInstallationstallationstallationsta

8 Determine the port address of each computer. For computers using PS/2 mouse, connect the computer's mouse and keyboard cables to the KVM Swi

10 Optional Rack Mount Accessories Figure 6 shows how to attach optional mounting brackets to the KVM Switch unit for standard 19-inch rack cabine

12 Multimedia Module An optional multimedia A/V module (MAV108) is used to select microphone, speaker and monitor signals from one out of eight or

14 OSD (On-Screen-Display) Operation KNV104D,KNV108D,KNV116D,KNV2108D,KNV2116D Figure 9: OSD screen illustration By hitting the left <CT

16 off. If Scan Type is 'Ready PC +1', only the power-on and eye mark selected computers will be displayed sequentially in Scan mode.